Enmet CP-10 Manual do Utilizador

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 Manual part number 80003-502 MCN-420, 04/22/09 CP-10 CON

CP-10 ENMET Corporation 8 4.0 Operation When the CP-10 is installed as described in Section 3, and in clean air, the POWER green LED is on, the d

CP-10 ENMET Corporation 9 4.2 Normal Display Mode When the CP-10 is installed as described in section 3, the POWER green LED is on, the display i

CP-10 ENMET Corporation 10 5.0 Maintenance The CP-10 maintenance menus that are accessed by pressing the MENU button and SELECT button as describ

CP-10 ENMET Corporation 11 Normal Gas Display 5ppm MenuPress and HOLD the MENU button for 2 – 4 seconds to enter the Maintenance Menus Exit

CP-10 ENMET Corporation 12 Normal Gas Display 20.9% MenuPress and HOLD the MENU button for 2 – 4 seconds to enter the Maintenance Menus Exi

CP-10 ENMET Corporation 13 5.2 CP-10 Maintenance Adjustments To set alarm points and 4-20mA span range enter the CP-10 maintenance menu. To enter

CP-10 ENMET Corporation 14 5.2.3 Alarm Set Points The CP-10 has three alarm set points set at the factory. These alarm points are normally set a

CP-10 ENMET Corporation 15 6.0 Technical Data and Specifications The CP-10 technical data and specifications: Electrical Power 15 Amp fused bra

CP-10 ENMET Corporation 16 7.0 WARRANTY ENMET warrants new instruments to be free from defects in workmanship and material under normal use for a

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instrument

Table of Contents 1.0 Introduction ...

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.7

CP-10 ENMET Corporation 1 1.0 Introduction The CP-10 Control Unit can monitor one channel of gas detection when connected to a Sensor Transmitter

CP-10 ENMET Corporation 2 2.0 Components of the CP-10 2.1 CP-10 elements See Figure 1 for location of elements: Feature Description Enclosure A

CP-10 ENMET Corporation 3 2.3 Circuit Board Features The Display Panel is attached by a cable and is released by unscrewing the 4 screws located

CP-10 ENMET Corporation 4 3.0 Installation of the CP-10 The CP-10 is supplied with a strain relief for a power line cord. Use this fitting or co

CP-10 ENMET Corporation 5 3.1.1 Wiring the CP-10 The electrical installation should conform to appropriate electrical codes, such as the National

CP-10 ENMET Corporation 6 3.2. Sensor/Transmitter Connection Sensor/Transmitters are connected to the CP-10 control unit with two or three-conduc

CP-10 ENMET Corporation 7 3.3 Relay Contacts Relay contacts are available for each alarm; these are SPDT, rated at 10Amp at 110VAC, and may be la